Katana Stator Cover How Do I Replace My Stator Cover On 1999 Gsx-f Katana 600?

How do i replace my stator cover on 1999 gsx-f katana 600? - katana stator cover

How can I change my stator on my GSXF 99 Katana 600, in pretty sure I simply removed and replaced with a new one, but I'm not a mechanic, so to ask me! thank you 4 your time.

3 comments:

HUZZ69 said...

Remove the cover right side and under the chin fairing, if necessary. Use to remove the right size Allen / Allen, and 5 screws. Remove the lid of the old. Remove cover any remaining grout from the left side of the old. Apply joint compound or new coverage. Insert a screw in the left and right (staor cover again) and are aligned with corresponding holes. Restart the two screws and then start the other three. When the five screws from the board and sealant tighten security. Replace the cloth when they were deported. Allow to dry completely before you start sealing. A simple procedure that is less than 30 minutes, should if necessary to remove the paneling. With the removal of disguises, about 60-90 minutes.

YFZ450R said...

I did it and can spoil.

A meeting is to advance. The old man is useless, you need to buy a new board and some Goop board.

The piece is too complicated to be reduced magnetized. Draw a diagram or take a picture, so you can see exactly how you feel right there.

The stator housing is not just a blanket. The internal mechanism is actually attached to the inside of the lid so that he would make the cover of the bike, then remove the stator to dismantle the bridge, while the bicycle is still connected by a cable.

If you do not return to exactly the right thing, the wheel will not start and when I try to get it running, connect the coils to cause any more damage. I've done worse and began to push the wheel to grind the gears, where the decline.

It's not like replacing a wheel cover for the documentation and take your time. I ended up with a business and someone who really knew what they were doing and talked together get.

kelly_f_... said...

Remove the screws to put the chaos couldnt cover up

Post a Comment